Die cutting machine is one of the carton mechanical equipment, which has an important advantage in the pointed die-cutting process. Good technical parameters promote continuous use in the carton industry. Different paper forms are used for cutting to meet the paper processing printing forms. Important transportation production processes are used to process different cartons to meet the use needs of the printing industry.

Operation skills of plate installation of manual flat die cutting machine:

In the actual operation, the plate mounting method materials used are exactly the same. According to the practice, the plate can be installed scientifically the plate printing can be checked: before the machine is put into operation, the height specification of the plate shall be checked to see whether they meet the size requirements of the die-cutting indentation machine, whether the wooden pillow plug is tight, whether the plate is flat, whether there is arch phenomenon, after the inspection is qualified, the plate shall be installed into the machine. The manual flat die-cutting machine has different operation in different process steps during the plate loading process. It needs to be loaded according to the form standard can be used in the carton printing process.

First pad knife line: roll another piece of paper. If there is a straight knife die knife that can come out, the copper iron sheet printed on the back of the knife. After several times of backing up the paper plate until the knife print is clear, cut off the knife print part with a rolled box blank paper, brush the paste on the back of the plate, then compress the iron frame with a spiral. Making the backing plate: to clean the stamping plate on the die-cutting machine, the adhesive must be removed, then the Yellow Board Paper No. 10 No. 20 is used to lay on the plate, the two ends are screwed. After rolling out the print, check it. Lay paper on the light part pad the plate with paper strip. If the knife is heavy, do move it temporarily. Cover the plate with thin kraft paper, insert the steel plate, tighten the screws.

Rewinding cutter line: use paper to rewinding several times to check if there is any place the cutter is blunt the indentation line can come out. If there is such a phenomenon, it needs to be padded. Indentation line has all part of the situation can come out, you can use a paper pad behind the plate. For the base plate with heavy weight on both ends light weight in the middle, use a line knife to dig out the heavy part of the line printing on the base plate. But it is suitable to dig too small, the knife cannot affect the knife line of other parts.