The paper table of carton mechanical machine is driven by hydraulic oil pump, the upper lower limit travel switches can effectively prevent the mechanical accident caused by the lifting out of position; the photoelectric device can control the automatic rise of the machine, maintain the normal paper feeding height; the paper feeding wheel uses the electric adjustment device when adjusting the gap, which is suitable for different types of corrugations with different thickness Paperboard: it is easy to find that when the quality of flat wire is good, the resistance of wire feeding is large, the spring of wire feeding wheel is too loose too tight, the screw fixed by wire feeding wheel is loose, the guide rail is deviated, the gear is engaged skewed, the bottom die of stapler punch is in the right position, the bottom die has obvious wear tear, etc., the above fault phenomenon is easy to occur.

When the photoelectric induction strength of the right baffle plate is too strong, the above faults are easy to occur. Therefore, the one-way knob on the side of the electric eye can be adjusted. Clockwise adjustment can increase the induction intensity, while anticlockwise adjustment can reduce the induction intensity. It is better to adjust it to normal induction, so that there is no abnormal situation after nailing. The solution to this problem is: use * * flat wire with good steel smooth surface coating; check whether all parts of the lower wire feeding will be blocked due to poor adjustment; adjust relevant parts of the machine so that the wire feeding movement can be easily freely maintained; the bottom die with serious wear shall be repaired replaced accordingly.

When there are pins in the mechanical binding head of the nail box carton, it is easy to affect the normal action of the clutch. Remove the side cover of the binding head, take out the punch, clean it, add lubricating oil, then install it again. If the positioning of the binding head is accurate, check whether F3 fuse 34-35 (AC), F9 fuse 50-51 (DC) brake coil resistance wire (15 Ω) are normal. If the upper binding head baffle photoelectricity If the inductive switch does act cannot sense the axis of the lower guide rail, which causes the phenomenon that the paper is nailed before being fed in, the sensing distance of the photoelectric switch can be adjusted; if the nail head has a continuous nailing action, check whether the electrical appliance is damaged.

If the photoelectric induction of the baffle plate is abnormal, this fault is easy to occur. The photoelectric induction device can be adjusted to maintain a proper sensing distance, the baffle plate can operate normally after the cardboard is fed. The automatic counting optical eye automatically counts the finished products records the output, can be set to separate send them out; the stapling head of the nail box machine is made of special steel, which has the effect of wear-resistant practical; the electronic control system of the carton machine uses the color touch screen, which provides a good human-computer interface, completes the automatic setting of the nail distance, the setting cancellation of the reinforcing nail, the fault finding, etc.